Subaru Legacy 2005 Service Manual page 2026

CONTROL SYSTEMS
11.Drive Select Cable
A: REMOVAL
1) Set the vehicle on a lift.
2) Set the drive select lever to "HI" position.
3) Push the both sides of knob and remove the cov-
er. (Rubber type)
(A)
(A) Cover
(B) Knob
4) Insert a screwdriver with thin tip into the both
sides of knob and push to remove the cover.
(Leather type)
5) Remove the bolts, and then remove the knob.
6) Remove the gear shift knob.
7) Remove the console box. <Ref. to EI-53, RE-
MOVAL, Console Box.>
8) Remove the front cover assembly.
9) Loosen the flange nut.
Drive Select Cable
(B)
CS-00395
CS-00401
CS-58
10) Remove the clamp, and then remove the drive
select cable from plate assembly.
11) Remove the boot and insulator assembly.
12) Remove the air intake chamber and the air in-
take duct. <Ref. to IN(H4SO 2.0)-7, REMOVAL, Air
Intake Chamber.> <Ref. to IN(H4SO 2.0)-8, RE-
MOVAL, Air Intake Duct.>
13) Remove the snap pin and clevis pin.
(A) Snap pin
(B) Clevis pin
CS-00402
CS-00312
(B)
(A)
CS-00403