Subaru Legacy 2005 Service Manual page 2362

AUTOMATIC TRANSMISSION
14.Front Vehicle Speed Sensor
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Remove the rear vehicle speed sensor.
NOTE:
Secure the harness of the rear vehicle speed sen-
sor to the transmission body using wire etc.
3) Remove the extension case.
4) Remove the intermediate case.
5) Remove the center differential carrier. <Ref. to
5AT-78, REMOVAL, Center Differential Carrier.>
6) Lay along the transmission case, and then re-
move the oil pan.
7) Remove the old gasket on the oil pan and trans-
mission case completely.
Front Vehicle Speed Sensor
8) Disconnect the front vehicle speed sensor con-
nector.
9) Remove the front vehicle speed sensor securing
bolt.
AT-01950
10) Remove the front vehicle speed sensor through
the hole of AT transmission main case.
B: INSTALLATION
1) Install the front vehicle speed sensor.
Tightening torque:
AT-01951
2) Connect the front vehicle speed sensor connec-
AT-01952
tor.
3) Apply proper amount of liquid gasket to the en-
tire oil pan mating surface.
5AT-52
⋅
7 N m (0.7 kgf-m, 5.2 ft-lb)
AT-01953
AT-01954
AT-01954