Subaru Legacy 2005 Service Manual page 2841

2. WAGON MODEL
Model
Wheel arch height
+12 mm
(Tolerance:
+0.47 in
( ))
−0.94 in
Camber (Tolerance: ±0°45'Differ-
ences between RH and LH 45' or
less)
Caster (Referential Value)
Front
Steering angle (Toler-
ance: ±1.5°)
Toe-in
Kingpin angle (Referential Value)
Diameter of stabilizer
Wheel arch height
+12 mm
(Tolerance:
+0.47 in
( ))
−0.94 in
Camber (Tolerance: ±0°45'Differ-
Rear
ences between RH and LH 45' or
less)
Toe-in
Thrust angle (Tolerance: ±0°30')
Diameter of stabilizer
NOTE:
• Front and rear toe-ins and front camber can be
adjusted. If the toe-in or camber tolerance exceeds
specifications, adjust them.
• Other items indicated in the specification table
cannot be adjusted. If other items exceed specifica-
tions, check the suspension parts and connections
for deformation, and replace with new ones as re-
quired.
General Description
2.0 i
−24 mm mm (in) 381 (15.0)
Inner
wheel
Outer
wheel
mm (in)
mm (in) 20 (0.79)
−24 mm mm (in)
mm (in)
mm (in)
2.5 i 2.0 GT
376 (14.8)
−0°15'
5°45'
37.3°
33.0°
0±3 (0±0.12) Toe angle (sum of both wheels): 0°±0°15'
13°45'
21 (0.84)
375 (14.8)
−0°30'
0±3 (0±0.12) Toe angle (sum of both wheels): 0°±0°15'
19.1 (0.75)
(1) Front
A − B = Positive: Toe-in, Negative: Toe-out
α = Each toe angle
FS-3
FRONT SUSPENSION
3.0 R spec.
3.0 R
B
372 (14.6)
−0°20' −0°25'
6°05'
37.2° 37.1°
32.9° 32.8°
13°50'
21 (0.83)
365 (14.4)
−0°40'
0°
17.3 (0.68)
B
(1)
A
OUTBACK
2.5 i,
OUTBACK
3.0 R
429 (16.9)
−0°30'
5°05'
37.8°
33.5°
12°25'
430 (16.9)
0°00'
FS-00001