Subaru Legacy 2005 Service Manual page 2131

5) Install new seal pipe to converter case.
(A) Seal pipe
6) Install the rubber seal to converter case.
(A) Rubber seal
7) Apply proper amount of liquid gasket to the en-
tire matching surface of converter case.
Liquid gasket:
THREE BOND 1215 (Part No. 004403007)
(A)
(A) THREE BOND 1215
(B) Rubber seal
Converter Case
8) Install the converter case assembly without
damaging bushing and oil seal.
Tightening torque:
41 N
AT-00176
9) Insert the inhibitor switch and transmission con-
(A)
nector to stay.
10) Install the air breather hose. <Ref. to 4AT-79,
INSTALLATION, Air Breather Hose.>
11) Install the oil cooler pipe. <Ref. to 4AT-70, IN-
STALLATION, ATF Cooler Pipe and Hose.>
12) Install the oil charge pipe with O-ring. <Ref. to
4AT-80, INSTALLATION, Oil Charge Pipe.>
13) Insert the input shaft while rotating it lightly by
hand, and then check the protrusion amount.
AT-00178
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
(B)
14) Install the torque converter clutch assembly.
<Ref. to 4AT-81, INSTALLATION, Torque Convert-
er Clutch Assembly.>
15) Install the transmission assembly into vehicle.
AT-00179
<Ref. to 4AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: INSPECTION
Measure the backlash, and then adjust it within
specification. <Ref. to 4AT-112, ADJUSTMENT,
Drive Pinion Shaft Assembly.>
4AT-103
AUTOMATIC TRANSMISSION
⋅
m (4.2 kgf-m, 30.4 ft-lb)
A
AT-03203
AT-03204