Subaru Legacy 2005 Service Manual page 2936

DIFFERENTIALS
NOTE:
The lock pin is staked at the pin hole end on the dif-
ferential carrier. Do not drive it out forcibly before
removing the stake.
ST 899904100 STRAIGHT PIN REMOVER
11) Draw out the pinion mate shaft and remove pin-
ion mate gears, side gears and thrust washers.
(Model without LSD)
NOTE:
The gears should be marked or kept separated
right and left, and front and rear as well as thrust
washers.
(A) Side gear
(B) Pinion mate gear
(C) Thrust washer
(D) Differential case
(E) Pinion mate shaft
12) Hold the companion flange with ST and remove
the self-locking nut.
ST 498427200 FLANGE WRENCH
Rear Differential (T-type)
ST
DI-00237
DI-00238
ST
DI-00071
13) Extract the companion flange with a puller.
14) Press the end of drive pinion shaft and extract it
together with rear bearing cone, pinion height ad-
just washer and washer.
NOTE:
Hold the drive pinion so as not to drop it.
ST 398467700
15) Remove the rear bearing cone from drive pin-
ion by supporting the cone with ST.
NOTE:
Place the replacer so that its center-recessed side
faces the pinion gear.
ST 398517700
DI-34
DI-00072
DRIFT
ST
DI-00073
REPLACER
ST
DI-00074