Subaru Legacy 2005 Service Manual page 2734

MANUAL TRANSMISSION AND DIFFERENTIAL
11) Install the ball, checking ball spring, gasket and
checking ball plug.
NOTE:
Use a new gasket and checking ball plug.
Tightening torque:
⋅
37 N m (3.8 kgf-m, 27.3 ft-lb)
(A) Checking ball plug
(B) Gasket
(C) Checking ball spring
(D) Ball
12) Install the bolt and gasket.
NOTE:
Use a new gasket.
Tightening torque:
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
13) Shift to 4th gear position using a screwdriver.
Main Shaft Assembly
(A)
(B)
(C)
(D)
MT-00554
MT-00546
6MT-72
14) Install the reverse idler holder.
(A)
(A) Reverse idler holder
15) Install the striking rod.
16) Install the transmission case. <Ref. to 6MT-65,
INSTALLATION, Transmission Case.>
17) Install the snap ring and washer of selected
main shaft.
18) Install the oil pump. <Ref. to 6MT-62, INSTAL-
LATION, Oil Pump.>
19) Install the center differential. <Ref. to 6MT-60,
INSTALLATION, Center Differential.>
20) Install the transfer driven gear. <Ref. to 6MT-
58, INSTALLATION, Transfer Driven Gear.>
21) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
22) Install the oil pipe, neutral position switch,
back-up light switch and harness. <Ref. to 6MT-42,
INSTALLATION, Oil Pipe.> <Ref. to 6MT-45, IN-
STALLATION, Neutral Position Switch.> <Ref. to
6MT-43, INSTALLATION, Back-up Light Switch.>
23) Install the manual transmission assembly to ve-
hicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
C: DISASSEMBLY
NOTE:
Each sleeve and hub engage at specified position.
Before disassembly, put marks on the engagement
position of sleeve and hub.
1) Secure the ST on workbench.
ST 18664AA000 BASE
2) Unlock the caulking of lock nut.
MT-00544