Table of Contents
Advertisement
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Remove the input shaft holder.
(A)
(A) Input shaft holder
(B) Input shaft
5) Remove the high-low switch. <Ref. to 5MT-40,
REMOVAL, Switches and Harness.>
6) Using the ST, drive out the straight pin, and re-
move the high-low shifter lever.
ST 398791700
STRAIGHT PIN REMOVER 2
NOTE:
When driving out the straight pin, remove it in the
direction that it does not hit against transmission
case.
(B)
(A) Straight pin
(B) High-low shifter lever
7) Remove the main shaft rear plate.
(A)
(A) Main shaft rear plate
Transmission Case
(B)
MT-00163
(A)
ST
MT-00164
MT-00165
8) Separate the transmission case into right and
left cases by loosening the seventeen coupling
bolts and nuts.
9) Remove the drive pinion shaft assembly from
transmission case LH.
NOTE:
Use a hammer handle, etc. to remove if too tight.
( B )
(A) Main shaft ASSY for dual-range
(B) Drive pinion shaft ASSY
10) Raise the main shaft assembly slightly, and re-
move the high-low shifter fork together with high-
low shifter shaft and washer.
NOTE:
Be careful not to drop the two high-low shifter piec-
es.
(A) High-low shifter fork
(B) Input shaft ASSY
5MT-56
MT-00160
( A )
MT-00161
( B )
( A )
MT-00169
Advertisement
Chapters
Table of Contents
