Subaru Legacy 2005 Service Manual page 2364

AUTOMATIC TRANSMISSION
15.Rear Vehicle Speed Sensor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Remove the intercooler. (Turbo model)
<Ref. to IN(H4DOTC)-12, REMOVAL, Intercool-
er.>
4) Remove the air intake chamber. (Non-turbo
model) <Ref. to IN(H6DO)-7, REMOVAL, Air Intake
Chamber.>
5) Disconnect the following connectors.
• Turbo model
(1) Transmission harness connectors
(2) Front oxygen (A/F) sensor
Rear Vehicle Speed Sensor
• Non-turbo model
IN-00203
6) Remove the transmission harness connector
and front oxygen (A/F) sensor connector from the
stay.
7) Lift-up the vehicle.
8) Clean the transmission exterior.
9) Drain the ATF completely. <Ref. to 5AT-28, RE-
PLACEMENT, Automatic Transmission Fluid.>
10) Remove the center exhaust pipe, rear exhaust
pipe and muffler. (Turbo model)
<Ref. to EX(H4DOTC)-6, REMOVAL, Center Ex-
haust Pipe.> <Ref. to EX(H4DOTC)-11, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H4DOTC)-
12, REMOVAL, Muffler.>
11) Remove the rear exhaust pipe and muffler.
(Non-turbo model) <Ref. to EX(H6DO)-7, REMOV-
AL, Rear Exhaust Pipe.> <Ref. to EX(H6DO)-9,
REMOVAL, Muffler.>
12) Remove the heat shield cover.
13) Remove the propeller shaft. <Ref. to DS-10,
REMOVAL, Propeller Shaft.>
AT-01364
14) Place the transmission jack under transmis-
sion.
NOTE:
Make sure that the support plate of transmission
jack does not touch the crossmember.
15) Remove the transmission rear crossmember
bolt.
AT-01379
5AT-54
(1)
(1) Front oxygen (A/F) sensor
(2) Transmission harness connectors
(2)
AT-02025
AT-01377