Table of Contents
Advertisement
MANUAL TRANSMISSION AND DIFFERENTIAL
C: DISASSEMBLY
NOTE:
Each sleeve and hub engage at specified position.
Before disassembly, put marks on the engagement
position of sleeve and hub.
1) Secure the ST on workbench.
ST 18664AA000 BASE
2) Unlock the caulking portion of lock nut.
3) Install the ST3 to lock nut, set the driven gear as-
sembly on ST, then remove the lock nut and wash-
er.
ST1 18666AA000 HOLDER
ST2 18664AA000 BASE
ST3 18620AA000 ADAPTER WRENCH
ST3
4) Install the ST1 to 4th gear, then remove the ball
bearing, 5th-6th driven gear and 3rd-4th driven
gear.
ST1 18723AA000 REMOVER
ST2 499877000
RACE 4-5 INSTALLER
ST2
ST1
(A) Ball bearing
(B) 5th-6th driven gear
(C) 3rd-4th driven gear
Driven Gear Assembly
ST2
ST1
MT-00588
(A)
(B)
(C)
MT-00589
6MT-84
5) Remove the driven gear key.
6) Remove the 2nd gear.
7) Remove the needle bearing and 1st-2nd sleeve.
(B)
(A) Needle bearing
(B) 1st-2nd sleeve
8) Remove the outer baulk ring, 2nd synchro cone
and inner baulk ring.
(A) Outer baulk ring
(B) 2nd synchro cone
(C) Inner baulk ring
MT-00590
MT-00591
(A)
MT-00592
(C)
(B)
(A)
MT-00593
Advertisement
Chapters
Table of Contents
