Subaru Legacy 2005 Service Manual page 2402

AUTOMATIC TRANSMISSION
34.Front Differential Assembly
A: REMOVAL
1) Remove the transmission assembly from vehi-
cle. <Ref. to 5AT-38, REMOVAL, Automatic Trans-
mission Assembly.>
2) Pull out the torque converter assembly. <Ref. to
5AT-70, REMOVAL, Torque Converter Assembly.>
3) Remove the transmission harness connector
from stay.
4) Remove the oil charge pipe. <Ref. to 5AT-69,
REMOVAL, Oil Charge Pipe.>
5) Remove the ATF filter inlet and outlet pipes.
<Ref. to 5AT-60, REMOVAL, ATF Filter.>
6) Separate the converter case and transmission
case. <Ref. to 5AT-82, REMOVAL, Converter
Case.>
7) Remove the differential side retainers using ST.
NOTE:
Hold the differential case assembly by hand to
avoid damaging the retainer mounting hole of con-
verter case.
ST 18630AA010 WRENCH COMPL RETAIN-
ER
8) Remove the differential assembly without dam-
aging the installation part of retainer.
B: INSTALLATION
1) When installing the differential assembly (A) to
case, be careful not to damage the inside of case
(particularly, the differential side retainer mating
surface).
(A)
2) Install the O-ring to left and right side retainer.
3) Install the side retainers using ST. <Ref. to 5AT-
92, REMOVAL, Front Differential Assembly.>
ST 18630AA010 WRENCH COMPL RETAIN-
ER
4) Adjust the front differential backlash. <Ref. to
5AT-95, ADJUSTMENT, Front Differential Assem-
bly.>
5) Install the lock plate (A).
Front Differential Assembly
Tightening torque:
6) Install the converter case to transmission case.
<Ref. to 5AT-82, INSTALLATION, Converter
Case.>
7) Install the transmission harness connector to the
stay.
8) Install the ATF filter pipe. <Ref. to 5AT-60, IN-
STALLATION, ATF Filter.>
9) Install the oil charge pipe with a O-ring. <Ref. to
5AT-69, INSTALLATION, Oil Charge Pipe.>
10) Install the torque converter assembly. <Ref. to
5AT-70, INSTALLATION, Torque Converter As-
sembly.>
11) Install the transmission assembly into vehicle.
<Ref. to 5AT-42, INSTALLATION, Automatic
Transmission Assembly.>
C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the taper roller bearing using ST and
press.
ST 498077000
AT-01987
5AT-92
⋅
25 N m (2.5 kgf-m, 18.4 ft-lb)
REMOVER
(A)
AT-01988
AT-00216