Subaru Legacy 2005 Service Manual page 2744

MANUAL TRANSMISSION AND DIFFERENTIAL
NOTE:
Set the indicator of height gauge near measuring
object, then lock the dial (1) as shown in the figure.
Turn dial (2) to set the indicator to edge surface of
bearing.
Measure five points of the ball bearing turning ev-
ery approx. 120°. Round off each two upper and
lower measurement value. Use the remaining mid-
dle value as measurement value.
4) According to measurement value, select the
snap ring and washer from the following table.
• Snap ring
H: mm (in) Part No.
270.83 — 271.40
805072010
(10.66 — 10.69)
271.41 — 271.98
805072011
(10.69 — 10.71)
271.99 — 272.56
805072012
(10.71 — 10.73)
• Washer
H: mm (in) Part No.
270.83 — 271.40
803067012
(10.66 — 10.69)
271.41 — 271.98
803067011
(10.69 — 10.71)
271.99 — 272.56
803067010
(10.71 — .73)
Main Shaft Assembly
(2)
(1)
MT-00585
Thickness:
mm (in)
1.65 (0.065)
1.95 (0.077)
2.25 (0.089)
Thickness:
mm (in)
1.6 (0.063)
1.3 (0.051)
1.0 (0.039)
6MT-82