Subaru Legacy 2005 Service Manual page 2720

MANUAL TRANSMISSION AND DIFFERENTIAL
15.Transfer Driven Gear
A: REMOVAL
1) Remove the manual transmission assembly
from vehicle. <Ref. to 6MT-34, REMOVAL, Manual
Transmission Assembly.>
2) Prepare the transmission for overhaul. <Ref. to
6MT-40, Preparation for Overhaul.>
3) Remove the extension case. <Ref. to 6MT-47,
REMOVAL, Extension Case.>
4) Remove the transfer driven gear.
B: INSTALLATION
1) Install the transfer driven gear.
2) If the bearing or transfer driven gear is replaced,
select the transfer driven thrust washer. <Ref. to
6MT-49, ADJUSTMENT, Extension Case.>
3) Install the extension case. <Ref. to 6MT-47, IN-
STALLATION, Extension Case.>
4) Install the manual transmission assembly into
vehicle. <Ref. to 6MT-36, INSTALLATION, Manual
Transmission Assembly.>
Transfer Driven Gear
C: DISASSEMBLY
1) Using the ST, remove the roller bearing (exten-
sion case side).
ST 498515700
2) Using the ST1 and ST2, remove the roller bear-
ing (transmission case side).
ST1 899858600
ST2 899864100
MT-00510
D: ASSEMBLY
1) Using the ST, install the roller bearing (extension
case side).
ST1 398177700
MT-00510
ST2 899864100
NOTE:
Do not apply pressure in excess of 10 kN (1 ton, 1.1
US ton, 1.0 Imp ton).
2) Using the ST, install the roller bearing of trans-
mission case side.
ST 499757002
6MT-58
REMOVER
ST
REMOVER
REMOVER
ST1
INSTALLER
REMOVER
(A)
(A) Roller bearing
INSTALLER
MT-00511
ST2
MT-00512
ST2
ST1
MT-00513