Gestetner G060 Service Manual page 1106

Firmware History for G307
FAX FCU:
DESCRIPTION OF MODIFICATION
•
Installed from the first mass production.
Corrects the following:
•
The AI tone is sent 1db higher than the
value set in the modem.
•
The machine sometimes freezes if the
operator attempts to cancel the printing out
of a report containing image data
•
If communication is interrupted (ECM
disabled) while the machine is receiving
MMR compressed data, the machine prints
out blank sheets or no sheets at all.
•
Even when paper is reloaded following
paper end during the printout of the power
failure report, the machine does not
continue printing and the job is cancelled.
•
If the Printing Numbers have been set for
reception mode or special sender and
Transfer Request is enabled, the machine
will print out the programmed number of
sheets in addition to transferring the data to
the proper destination.
Corrects the following:
•
Broadcasting sometimes fails when sending
through PCFax.
•
Memory transmission sometimes fails
following repetition of On-hook
Off-hook.
•
The following bit switch has been added.
SYSTEM SWITCH 19
No. FUNCTION
4 Number of jobs controlled for
PC-FAX TX
0: 64 Jobs
1: No limitations (but conforms
to device limitations)
FIRMWARE
LEVEL
G3075771 B
G3075771 C
G3075771 D
# reg
COMMENTS
Sets the number of jobs controlled
for PC-FAX transactions. If "1" is
selected (no limitations), control is
relinquished to the device
(standard 400, expandable to
800).
SERIAL
FIRMWARE
NUMBER
VERSION
December 2.00.04
2001
February 3.00.02
2002
October 4.00.00
2002
CHECK
SUM
8EAD
6FFB
672A
Page 2 of 2