Transport after installation
WARNING:
Before moving the printer, always switch off the machine.
WARNING:
3
The printer must only be transported with all covers closed.
Remove Drystar 5301, Drystar 5302 from pallet
WARNING:
Do not lift the printer by the output tray.
WARNING:
When transporting the printer, the stability and the structure of
the tabletop have to be taken into account. The printer should
not be placed on a soft surface, since this might prevent
appropriate ventilation and cause overheating. Make sure the
printer is placed on a stable, hard surface table.
WARNING:
The appliance may not be transported continuously from one
location to the other.
1
Lift printer from pallet with 3 persons.
WARNING:
Locate
2 handles
at left,
front and
right side.
2
If only 2 persons are available, lift as
shown below.
3
Put printer on a table. Always put tray
side at front.
Figure 2: Transport possibilities
Drystar 5301, Drystar 5302 | Introduction | 29
A
Locate
2 handles
at left,
front and
right side.
2
If only 2 persons are available, li
shown below.
The table should be able to suppor
printer's full weight (90 kg).
2831E EN 20161128 1410