Chrysler 2005 Crossfire SRT6 Service Manual page 1954

9 - 30 ENGINE - ELECTRICAL DIAGNOSTICS
(P0106) MAP SENSOR PERFORMANCE (CONTINUED)
13.
SENSOR GROUND CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the Sensor Ground circuit from the MAP
Sensor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Go To 14
No >> Repair the Sensor Ground circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
14.
5-VOLT SUPPLY CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the 5-Volt Supply circuit from the MAP Sen-
sor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace the Manifold Absolute Pressure Sensor.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the 5-Volt Supply circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
ZH