Chrysler 2005 Crossfire SRT6 Service Manual page 1984

9 - 60 ENGINE - ELECTRICAL DIAGNOSTICS
(P0113) INTAKE AIR TEMPERATURE SENSOR CIRCUIT HIGH (EXCEPT SRT) (CONTINUED)
8.
IAT SIGNAL CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
Measure the voltage of the IAT Signal circuit at the MAF/IAT Sensor
harness connector.
Is the voltage below 1.0 volt?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the IAT Signal circuit for a short to voltage.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
9.
IAT SENSOR SIGNAL CIRCUIT OPEN
Turn the ignition off.
Disconnect the PCM C3 harness connector.
Note: Check connectors — Clean/repair as necessary.
Measure the resistance of the IAT Sensor Signal circuit from the MAF/
IAT Sensor harness connector to the PCM C3 harness connector.
Is the resistance below 5.0 ohms?
Yes >> Replace and program the Powertrain Control Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/POWERTRAIN
REMOVAL).
Perform POWERTRAIN VERIFICATION TEST - VER 2.
No >> Repair the IAT Sensor Signal circuit for an open.
Perform POWERTRAIN VERIFICATION TEST - VER 2.
CONTROL MODULE
CONTROL MODULE
-
-
ZH