Chrysler 2005 Crossfire SRT6 Service Manual page 1973

ZH
(P0113) INTAKE AIR TEMPERATURE SENSOR CIRCUIT HIGH (SRT) (CONTINUED)
When Monitored and Set Condition
• When Monitored: With the ignition on.
• Set Condition: An improper voltage level has been detected by the Powertrain Control Module (PCM) on the
Intake Air Temperature Sensor Signal circuit.
IAT SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE
IAT SENSOR SIGNAL CIRCUIT SHORT TO GROUND
IAT SENSOR SIGNAL CIRCUIT SHORT TO SENSOR GROUND CIRCUIT
IAT SENSOR SIGNAL CIRCUIT OPEN
SENSOR GROUND CIRCUIT OPEN
INTAKE AIR TEMPERATURE SENSOR
POWERTRAIN CONTROL MODULE
For a complete Powertrain Control Module Circuit Diagram, (Refer to 9 - ENGINE - SCHEMATICS AND DIA-
GRAMS).
Diagnostic Test
1.
PRE-DIAGNOSTIC CHECK OUT
Note: Always perform diagnostics with a fully charged battery.
Note: Check connectors — Clean/repair as necessary. Poor pin to
terminal connections can set DTCs.
Note: Check for applicable TSBs related to the problem.
Turn the ignition on.
With the DRB III , read PCM DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and
connectors. Repair as necessary.
Perform this procedure prior to symptom diagnosis.
Continue
Go To 2
ENGINE - ELECTRICAL DIAGNOSTICS 9 - 49
POSSIBLE CAUSES