Chrysler 2005 Crossfire SRT6 Service Manual page 1974

9 - 50 ENGINE - ELECTRICAL DIAGNOSTICS
(P0113) INTAKE AIR TEMPERATURE SENSOR CIRCUIT HIGH (SRT) (CONTINUED)
2.
CHECK FOR CURRENT DTC
Note: If the PCM detects and stores a DTC, the PCM also stores
the engine/vehicle operating conditions under which the DTC was
set. Some of these conditions are displayed on the DRB III at the
same time the DTC is displayed.
Note: Before erasing stored DTCs, record these conditions.
Attempting to duplicate these conditions may assist when check-
ing for a DTC.
With the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read PCM DTCs.
Did this DTC set again?
Yes >> Go To 3
No >> Go To 10
3.
CHECK FOR IAT SENSOR SIGNAL CIRCUIT SHORT TO VOLTAGE
Turn the ignition off.
Disconnect the Intake Air Temperature Sensor harness connector.
Note: Check connectors — Clean/repair as necessary.
Turn the ignition on.
With the DRB III , erase PCM DTCs.
Note: It maybe necessary to road test the vehicle for this DTC to
set.
With the DRB III , read PCM DTCs.
Is DTC P0113 INTAKE AIR TEMPERATURE SENSOR CIRCUIT
HIGH present?
Yes >> Go To 4
No >> Go To 8
ZH