Snmp Trap Link-Status; Syslog Commands; Clear Logging - Dell Z9500 Reference Manual

Hide thumbs Also See for Z9500:
Table of Contents

Advertisement

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
Z9500
Syntax
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status
command.
Defaults
Enabled.
Command
INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Usage
If the interface is expected to flap during normal usage, you could disable this
Information
command.

Syslog Commands

The following commands allow you to configure logging functions on all Dell Networking switches.

clear logging

Clear the messages in the logging buffer.
Z9500
Syntax
clear logging
Defaults
none
1680
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog

Advertisement

Table of Contents
loading

Table of Contents