Engine Stop Relay - Honda CB 600F Hornet 2007 Shop Manual

INSPECTION
Remove the seat (page 2-4).
Disconnect the bank angle sensor 3P (Green) con­
nector and connect the special tool between the
connectors.
Inspection test harness
TOOL:
Turn the ignition switch ON and engine stop switch
· · o . . .
Measure the voltage between the following termi­
nals of the test harness.
TERMINAL
White clip(+)
Green clip(+) - Red clip (-)
Turn the ignition switch OFF and remove the inspec­
tion test harness.
Connect the bank angle sensor 3P (Green) connec­
tor.
Remove the screws, washers and the bank angle
sensor.
Place the bank angle sensor horizontal as shown,
and turn the ignition switch ON and engine stop
switch
The bank angle sensor is normal if the engine stop
"O'".
relay clicks and power supply is closed.
Incline the bank angel sensor approximately 60
degrees to the left or right with keeping the ignition
switch ON and engine stop switch
The bank angle sensor is normal if the engine stop
relay clicks and power supply is open.
If you repeat this test, first turn the ignition switch
OFF, then turn the ignition switch ON and engine
stop switch

ENGINE STOP RELAY

INSPECTION
Remove the rear cowl (page 2-6).
Remove the engine stop relay from the rubber
holder.
Disconnect the engine stop relay connector.
07GMJ-ML80100
STANDARD
- Red clip(-) Battery voltage
0-1V
"O".
"O".
FUEL SYSTEM (PGM-FI)
60 BANK ANGLE POSITION
r
°
Q�
(approximately} 60' � -
NOR MAL
POSITION
�
�
60' (opproximately}
:\
5-95