Sflow Polling (Interface Mode); Sflow Sampling - Dell PowerConnect M6348 Cli Reference Manual

sflow polling (Interface Mode)

Use the sflow polling command in Interface Mode to enable a new sflow poller instance for this
data source if rcvr_idx is valid. Use the "no" form of this command to reset poller parameters to
the defaults.
Syntax
rcvr-index
sflow
no sflow polling
rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval — The sFlow instance polling interval. A poll interval of 0 disables counter
•
sampling. A value of n means once in n seconds a counter sample is generated. (Range: 0 -
86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
console(config-if-1/g2)#sflow 1 polling 6055

sflow sampling

Use the sflow sampling command to enable a new sflow sampler instance for this data source if
rcvr_idx is valid. Use the "no" form of this command to reset sampler parameters to the default.
Syntax
rcvr-index
sflow
no sflow rcvr-index
rcvr-index —The sFlow Receiver for this sFlow sampler to which flow samples are to be sent.
•
If no receiver is configured, then no packets will be sampled. Only active receivers can be set.
If a receiver expires, then all samplers associated with the receiver will also expire. (Range:
1–8).
1030
poll-interval
polling
interfaces sampling-rate
sampling ethernet
sampling ethernet interfaces
[ size ]