Hostname; Member - Dell PowerConnect M6348 Cli Reference Manual

User Guidelines
No specific guidelines.
Example
console(config)#cut-through mode
The mode (enable) is effective from the next reload of
Switch/Stack.

hostname

Use the hostname command in Global Configuration mode to specify or modify the switch host
name. To restore the default host name, use the no form of the command.
Syntax
name
hostname
no hostname
name — The name of the host. (Range: 1–255 characters)
•
Default Configuration
Host name not configured.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the switch host name.
console(config)# hostname Dell

member

Use the member command in Stack Global Configuration mode to configure the switch.
Execute this command on the Management Switch. To remove a switch from the stack, use the
no form of the command.
NOTE: The "no" form of the command may not be used if the member is present in the stack.
1091