Ping - Dell PowerConnect M6348 Cli Reference Manual

Command Mode
Stack Global Configuration mode
User Guidelines
Upon execution, the entire stack, including all interfaces in the stack, are unconfigured and
reconfigured with the configuration on the new Management Switch.
After the reload is complete, all stack management capability must be performed on the new
Management Switch.
To preserve the current configuration across a stack move, execute the copy configuration
command before performing the stack move. A stack move causes all routes and layer 2
addresses to be lost. This command is executed on the Management Switch. The administrator
is prompted to confirm the management move.
Example
The following example displays how to move the Management Switch functionality from switch
"1" to switch "8."
console(config)#stack
console(config)#movemanagement 1 2

ping

Use the ping command in User EXEC mode to check the accessibility of the desired node on
the network.
Syntax
ipaddress
ping [ ip | ipv6 ]
ipaddress — IP address to ping (contact).
•
hostname — Hostname to ping (contact) (Range: 1–158 characters).
•
count — Number of packets to send (Range: 1–15 packets).
•
interval — The time between Echo Requests, in seconds (Range: 1–60 seconds).
•
size — Number of data bytes in a packet (Range: 0–65507 bytes).
•
Default Configuration
The default count is 4.
The default interval is 3 seconds.
The default size is 0 data bytes.
hostname count
| [ repeat
interval
] [ timeout ] [ size
size
]
1093