Mpls Ldp Autoconfig - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

mpls ldp autoconfig

From Interface Configuration mode and Subinterface Configuration mode:
Syntax
[ no ] mpls ldp { isis | ospf } autoconfig
From Router Configuration mode for IS-IS:
mpls ldp autoconfig [ level-1 | level-2 | level-1-2 ]
no mpls ldp autoconfig
From Router Configuration mode for OSPF:
mpls ldp autoconfig [ areaId | areaIdInt ]
no mpls ldp autoconfig
Command introduced in JUNOSe Release 8.1.0.
Release Information
In Interface Configuration mode, creates LDP on the current interface. The no version
Description
removes LDP from the interface.
In Router Configuration mode, creates LDP on all interfaces in the IS-IS or OSPF
router, on interfaces in the specified level (IS-IS), or on interfaces in the specified
area (OSPF). The no version removes the LDP configuration for all qualifying
interfaces.
Options
Interface Configuration, Router Configuration, Subinterface Configuration
Mode
1334
mpls ldp autoconfig
level-1 Enables LDP on all IS-IS level 1 interfaces
level-1-2 Enables LDP on all IS-IS level 1-2 interfaces
level-2 Enables LDP on all IS-IS level-2–only interfaces
areaId OSPF area ID in IP address format
areaIdInt OSPF area ID as a decimal value in the range 0–4294967295