ST STM32WL55JC Reference Manual page 921

RM0453
For example, the timer DMA burst feature could be used to update the contents of the CCRx
registers (x = 2, 3, 4) on an update event, with the DMA transferring half words into the
CCRx registers.
This is done in the following steps:
1. Configure the corresponding DMA channel as follows:
–
–
–
–
2. Configure the DCR register by configuring the DBA and DBL bit fields as follows:
DBL = 3 transfers, DBA = 0xE.
3. Enable the TIMx update DMA request (set the UDE bit in the DIER register).
4. Enable TIMx
5. Enable the DMA channel
This example is for the case where every CCRx register is to be updated once. If every
CCRx register is to be updated twice for example, the number of data to transfer should be
6. Let's take the example of a buffer in the RAM containing data1, data2, data3, data4, data5
and data6. The data is transferred to the CCRx registers as follows: on the first update DMA
request, data1 is transferred to CCR2, data2 is transferred to CCR3, data3 is transferred to
CCR4 and on the second update DMA request, data4 is transferred to CCR2, data5 is
transferred to CCR3 and data6 is transferred to CCR4.
Note: A null value can be written to the reserved registers.
27.3.17 Using timer output as trigger for other timers (TIM16/TIM17)
The timers with one channel only do not feature a master mode. However, the OC1 output
signal can be used to trigger some other timers (including timers described in other sections
of this document). Check the "TIMx internal trigger connection" table of any TIMx_SMCR
register on the device to identify which timers can be targeted as slave.
The OC1 signal pulse width must be programmed to be at least 2 clock cycles of the
destination timer, to make sure the slave timer will detect the trigger.
For instance, if the destination's timer CK_INT clock is 4 times slower than the source timer,
the OC1 pulse width must be 8 clock cycles.
27.3.18 Debug mode
When the microcontroller enters debug mode (Cortex
either continues to work normally or stops, depending on DBG_TIMx_STOP configuration
bit in DBG module. For more details, refer to
peripheral freeze register
For safety purposes, when the counter is stopped (DBG_TIMx_STOP = 1), the outputs are
disabled (as if the MOE bit was reset). The outputs can either be forced to an inactive state
(OSSI bit = 1), or have their control taken over by the GPIO controller (OSSI bit = 0) to force
them to Hi-Z.
DMA channel peripheral address is the DMAR register address
DMA channel memory address is the address of the buffer in the RAM containing
the data to be transferred by DMA into the CCRx registers.
Number of data to transfer = 3 (See note below).
Circular mode disabled.
(DBGMCU_APB2FZR).
General-purpose timers (TIM16/TIM17)
®
Section 38.12.7: DBGMCU CPU1 APB2
RM0453 Rev 2
-M4 core halted), the TIMx counter
921/1454
944