Configure A Wireless Wide Area Network (Wwan) - Digi LR54 User Manual

Interfaces
a. Add a MAC address to the denylist:
(config network interface my_wan)> add mac_denylist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Add a MAC address to the allowlist:
(config network interface my_wan)> add mac_allowlist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
11. Save the configuration and apply the change:
(config network interface my_wan)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wireless Wide Area Network (WWAN)

Configuring a Wireless Wide Area Network (WWAN) involves configuring the following items:
Required configuration items
The interface type: Modem.
n
The firewall zone: External.
n
The cellular modem that is used by the WWAN.
n
Additional configuration items
SIM selection for this WWAN.
n
The SIM PIN.
n
The SIM phone number for SMS connections.
n
Enable or disable roaming.
n
SIM failover configuration.
n
APN configuration.
n
The custom gateway/netmask.
n
IPv4 configuration:
n
LR54 User Guide
Wide Area Networks (WANs)
134