Configure A Wireless Wide Area Network (Wwan) - Digi IX20W-PR User Manual

Interfaces
a. Add a MAC address to the denylist:
(config network interface my_wan)> add mac_denylist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MACaddress, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MACaddress allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Add a MAC address to the allowlist:
(config network interface my_wan)> add mac_allowlist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MACaddress, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
11. See Configure SureLink active recovery to detect WAN/WWAN failures
configuring SureLink for active recovery.
12. Save the configuration and apply the change
(config network interface my_wan)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wireless Wide Area Network (WWAN)

Configuring a Wireless Wide Area Network (WWAN) involves configuring the following items:
Required configuration items
n The interface type: Modem.
n The firewall zone: External.
n The cellular modem that is used by the WWAN.
Additional configuration items
n SIM selection for this WWAN.
n The SIM PIN.
n The SIM phone number for SMS connections.
n Enable or disable roaming.
n SIM failover configuration.
n APN configuration.
n The custom gateway/netmask.
IX20 User Guide
Wide Area Networks (WANs)
for information about
163