Configure A Wireless Wide Area Network (Wwan) - Digi Connect EZ 4 User Manual

Interfaces
iv. The accounting server port number defaults to 1813. To set an alternate port number:
(config network interface my_wan)> 802_1x accounting port port
(config network interface my_wan)>
9. (Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MAC address to the denylist:
(config network interface my_wan)> add mac_denylist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
10. (Optional) Configure the MAC address allowlist.
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Add a MAC address to the allowlist:
(config network interface my_wan)> add mac_allowlist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MAC address.
11. Save the configuration and apply the change:
(config network interface my_wan)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wireless Wide Area Network (WWAN)

Configuring a Wireless Wide Area Network (WWAN) involves configuring the following items:
Required configuration items
The interface type: Modem.
n
The firewall zone: External.
n
The cellular modem that is used by the WWAN.
n
Additional configuration items
SIM selection for this WWAN.
n
The SIM PIN.
n
Digi Connect EZ 4/4i User Guide
Wide Area Networks (WANs)
113