Table of Contents
Advertisement
User authentication
(config)> auth group test acl nagios enable true
(config)>
7. (Optional) Enable users that belong to this group to access the Bluetooth scanning service:
(config)> auth group test acl bluetooth_scanner enable true
(config)>
8. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service:
(config)> auth group group test acl wifi_scanner enable true
(config)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete an authentication group
By default, the Connect EZ device has two preconfigured authentication groups: admin and serial.
These groups cannot be deleted.
To delete an authentication group that you have created:
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. Click the menu icon (...) next to the group to be deleted and select Delete.
Digi Connect EZ 4/4i User Guide
Authentication groups
665
Advertisement
Table of Contents
