Table of Contents
Advertisement
User authentication
(config)>
ii. Add a captive portal:
(config)> add auth group test acl portal portals end portal1
(config)>
6. (Optional) Configure Nagios monitoring:
(config)> auth group test acl nagios enable true
(config)>
7. (Optional) Enable users that belong to this group to access the Bluetooth scanning service:
(config)> auth group test acl bluetooth_scanner enable true
(config)>
8. (Optional) Enable users that belong to this group to access the Wi-Fi scanning service:
(config)> auth group group test acl wifi_scanner enable true
(config)>
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete an authentication group
By default, the IX20 device has two preconfigured authentication groups: admin and serial. These
groups cannot be deleted.
To delete an authentication group that you have created:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
no redirect_url
no terms
timeout 24h
no title
Authentication groups
593
Advertisement
Table of Contents
