Download Mibs - Digi IX40 User Manual

Services
(config)> service snmp privacy_protocol AES
(config)>
12. (Optional) Add Dynamic SNMP Properties to expose specific details about your device for
SNMP monitoring that are not included in the standard MIB.
(config) service snmp runt> add end value
(config)>
Where value can be any element in the runtime table you want to expose to SNMP monitoring
(for example, "system.cpu_temp" or "system.name").
13. (Optional) Enable read-only access to to SNMP version 2c.
(config)> service snmp enable 2c true
(config)>
14. Save the configuration and apply the change
(config)> save
Configuration saved.
>
15. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.
Required configuration items
n Enable SNMP.
To download a .zip archive of the SNMP MIBs supported by this device:
É
Web
Log into the IX40 WebUI as a user with full Admin access rights.
1. Enable SNMP.
See Configure Simple Network Management Protocol (SNMP)
and configuring SNMP support on the IX40 device.
2. On the main menu, click Status. Under Services, click SNMP.
Note If you have recently enabled SNMP and the SNMP option is not visible, refresh your
browser.
IX40 User Guide
Simple Network Management Protocol (SNMP)
for information about enabling
560