Download Mibs - Digi Connect IT 4 User Manual

Services
13. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
14. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.
Required configuration items
Enable SNMP.
n
To download a .zip archive of the SNMP MIBs supported by this device:

Web
1. Log into the Connect IT 4 WebUI as a user with Admin access.
2. Enable SNMP.
See Configure Simple Network Management Protocol (SNMP)
and configuring SNMP support on the Connect IT 4 device.
3. On the main menu, click Status. Under Services, click SNMP.
Note If you have recently enabled SNMP and the SNMP option is not visible, refresh your
browser.
The SNMP page is displayed.
4. Click Download.
Digi Connect IT® 4 User Guide
Simple Network Management Protocol (SNMP)
for information about enabling
508