Show Vrrp Status And Statistics - Digi IX10-00G4 User Manual

Routing
b. Set the end address to 250:
(config)> network interface eth ipv4 dhcp_server lease_end 250
(config)>
3. Set the DHCP server gateway type to custom:
(config)> network interface eth ipv4 dhcp_server advanced gateway custom
(config)>
4. Set the custom gateway to 192.168.3.3:
(config)> network interface eth ipv4 dhcp_server advanced gateway_custom
192.168.3.3
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show VRRP status and statistics

This section describes how to display VRRP status and statistics for a IX10 device. VRRP status is
available from the Web UI only.

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
device.
b. Click the Device ID.
c. Click Settings.
d. Click to expand Config.
Web UI:
IX10 User Guide
Virtual Router Redundancy Protocol (VRRP)
Use Digi Remote Manager to view and manage your
251