Show Vrrp Status And Statistics - Digi IX10 User Manual

Hide thumbs Also See for IX10:

Table of Contents

4. Set https://remotemanager.digi.com as the hostname to ping:

(config network interface eth ipv4 surelink target 0)> ping_host

https://remotemanager.digi.com(config network interface eth ipv4 surelink

Task 5: Configure the DHCP server for ETH on device two

1. Type ... to return to the root of the configuration prompt:

(config network interface eth ipv4 surelink target 0)> ...

2. Set the start and end addresses of the DHCP pool to use to assign DHCP addresses to clients:

a. Set the start address to 200:

(config)> network interface eth ipv4 dhcp_server lease_start 200

b. Set the end address to 250:

(config)> network interface eth ipv4 dhcp_server lease_end 250

3. Set the DHCP server gateway type to custom:

(config)> network interface eth ipv4 dhcp_server advanced gateway custom

4. Set the custom gateway to 192.168.3.3:

(config)> network interface eth ipv4 dhcp_server advanced gateway_custom

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Show VRRP status and statistics

This section describes how to display VRRP status and statistics for a IX10 device. VRRP status is

available from the Web UI only.

IX10 User Guide

Virtual Router Redundancy Protocol (VRRP)