Table of Contents
Advertisement
Hotspot
Repeat to add additional IP addresses or subnets.
7. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the hotspot to use RADIUS users authentication
RADIUS users authentication requires each hotspot user to enter a username and password. Users are
created on an external RADIUS server, and the username and password is validated by the external
RADIUS server.
By default, the router redirects unauthenticated users to the HTML authentication page located on the
router at etc/config/hotspot/login.html. You can customize the authentication page as needed, or
host an authentication page on a remote server. See
information.
Required configuration items
Create a new hotspot
n
Select RADIUS users authentication.
n
IP address or hostname of the primary RADIUS server.
n
Users configured on the RADIUS server.
n
RADIUS server secret.
n
RADIUS NAS ID.
n
Domain name or subnet of the RADIUS server included in the "white list" of servers that
n
unauthenticated hotspot clients can access.
Additional configuration items
IP address or hostname of the secondary RADIUS server to be used if the primary
n
RADIUS server is unreachable.
Modify the local HTML authentication page, /etc/config/hotspot/login.html, or enter the
n
name of an alternative HTML authentication page stored in the same directory, or identify a
remote web server to host the HTML authentication page and include that server in the "white
list" of servers that unauthenticated hotspot clients can access. See
login page
Hotspot LAN configuration:
Configure hotspot for RADIUS users authentication from the WebUI
TX54 User Guide
or
Enable hotspot using the default
for further information.
Customize the hotspot login page
configuration.
Customize the hotspot
Hotspot configuration
for further
324
Advertisement
Table of Contents
