Configure A Wi-Fi Client And Add Client Networks - Digi LR54 User Manual

Wi-Fi
2 /network/device/eth4
3 /network/wifi/ap/digi_ap1
4 /network/wifi/ap/digi_ap2
(config network interface LAN2)>
b. Use the index number to delete digi_ap2:
(config network interface LAN2)> del .. .. bridge lan1 device 4
(config network interface LAN2)>
7. Save the configuration and apply the change:
(config network interface LAN2)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wi-Fi client and add client networks

Required configuration items
Create the Wi-Fi client.
n
The LR54W device's Wi-Fi radio that the Wi-Fi client will use.
n
SSID of the access point that the client will log into.
n
The encryption type used by the access point:
n
If a personal or mixed mode option is selected, identify the Pre-shared key.
l
If an enterprise option is selected:
l
o Select the Extensible Authentication Protocol (EAP), one of:
TLS: Client certificate authentication.
o
If TLS is selected, include:
o
o
o
o
o
PEAP: Username/password authentication.
o
If PEAP is selected, identify the username and password.
SCEP certificates: Simple Certificate Enrollment Protocol (SCEP) certificate
o
management.
If SCEP certificates is selected:
LR54 User Guide
The username.
The CA certificate in PEM format.
The client certificate in PEM format.
The private key in PEM format.
(Optional) The private key passphrase.
Configure a Wi-Fi client and add client networks
300