Table of Contents
Advertisement
Wi-Fi
e. Set the IP address and subnet mask of the LAN:
(config network interface LAN2)> ipv4 address address/mask
(config network interface LAN2)>
f. Enable the DHCP server:
(config network interface LAN2)> ipv4 dhcp_server enable true
(config network interface LAN2)>
6. Save the configuration and apply the change
(config network interface LAN2)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a Wi-Fi client and add client networks
Required configuration items
n
Create the Wi-Fi client.
n
The IX20Wdevice's Wi-Fi radio that the Wi-Fi client will use.
n
SSID of the access point that the client will log into.
n
The encryption type used by the access point:
If a personal or mixed mode option is selected, identify the Pre-shared key.
l
If an enterprise option is selected:
l
o
Select the Extensible Authentication Protocol (EAP), one of:
o
TLS: Client certificate authentication.
If TLS is selected, include:
o
o
o
o
o
o
PEAP: Username/password authentication.
If PEAP is selected, identify the username and password.
o
SCEP certificates: Simple Certificate Enrollment Protocol (SCEP) certificate
management.
If SCEP certificates is selected:
IX20 User Guide
The username.
The CA certificate in PEM format.
The client certificate in PEM format.
The private key in PEM format.
(Optional) The private key passphrase.
Configure a Wi-Fi client and add client networks
349
Advertisement
Table of Contents
