Configure A Wi-Fi Client And Add Client Networks - Digi TX54 User Manual

Wi-Fi
f. Enable the DHCP server:
(config network interface LAN2)> ipv4 dhcp_server enable true
(config network interface LAN2)>
6. Remove the digi_ap2 access point from the LAN1 bridge:
This step applies to dual-Wi-Fi models only, and only if you are using both preconfigured
access points, rather than creating a new access point.
a. View the devices configured for the LAN1 bridge:
(config network interface LAN2)> show .. .. bridge lan1 device
0 /network/device/eth2
1 /network/device/eth3
2 /network/device/eth4
3 /network/wifi/ap/digi_ap1
4 /network/wifi/ap/digi_ap2
(config network interface LAN2)>
b. Use the index number to delete digi_ap2:
(config network interface LAN2)> del .. .. bridge lan1 device 4
(config network interface LAN2)>
7. Save the configuration and apply the change:
(config network interface LAN2)> save
Configuration saved.
>
8. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wi-Fi client and add client networks

Required configuration items
Create the Wi-Fi client.
n
The TX54 device's Wi-Fi radio that the Wi-Fi client will use.
n
SSID of the access point that the client will log into.
n
The encryption type used by the access point:
n
If a personal or mixed mode option is selected, identify the Pre-shared key.
l
If an enterprise option is selected:
l
o Select the Extensible Authentication Protocol (EAP), one of:
TLS: Client certificate authentication.
o
If TLS is selected, include:
o
o
TX54 User Guide
The username.
The CA certificate in PEM format.
Configure a Wi-Fi client and add client networks
273