Table of Contents
Advertisement
Wi-Fi
e. Set the IP address and subnet mask of the LAN:
(config network interface LAN2)> ipv4 address address/mask
(config network interface LAN2)>
f. Enable the DHCP server:
(config network interface LAN2)> ipv4 dhcp_server enable true
(config network interface LAN2)>
6. Save the configuration and apply the change:
(config network interface LAN2)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a Wi-Fi client and add client networks
Required configuration items
Create the Wi-Fi client.
n
The IX20W device's Wi-Fi radio that the Wi-Fi client will use.
n
The Wi-Fi network that the client will log into:
n
SSID of the Wi-Fi network's access point.
l
Type of security, and user name and/or password if applicable, used by the access point.
l
WAN assignment. Once you configure a Wi-Fi client, you must assign the Wi-Fi client to a WAN.
n
See
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs)
information.
Additional configuration items
Enable and configure background scanning, which allows the Wi-Fi client to move between
n
access points that have the same SSID as their signal strength varies.
Additional access points that client will attempt to use. If connection to one access point fails,
n
the device will attempt to connect to the next access point in the list.
Note
The IX20W device supports a maximum of ten enabled Wi-Fi clients, regardless of the number of
enabled access points.
To configure a Wi-Fi client:
WebUI
IX20 User Guide
Configure a Wi-Fi client and add client networks
for further
220
Advertisement
Table of Contents
