Commands; Show Inlinepower; Set Inlinepower Threshold - Enterasys D2 D2G124-12P Cli Reference Manual

Commands

The commands used to review and set system power parameters are listed below.
For information about...

show inlinepower

set inlinepower threshold

set inlinepower trap
show port inlinepower
set port inlinepower
show inlinepower
Use this command to display system power properties.
Syntax
show inlinepower
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display system power properties:
D2(su)->show inlinepower
Detection Mode
Unit
----
1
set inlinepower threshold
Use this command to set the power usage threshold.
Syntax
set inlinepower threshold usage-threshold
Parameters
threshold value
: auto
Status Power(W)
------ --------
auto 480
Specifies a power threshold as a percentage of total system power usage.
Valid values are 11 to 100.
Consumption(W) Usage(%)
-------------- --------
0.00 0.00
show inlinepower
Refer to page...
2-31
2-31
2-32
2-32
2-33
Threshold(%) Trap
------------ ----
80 enable
D-Series CLI Reference 2-31