Configuring Traffic Mirroring And Redirecting Traffic To A Port - 3Com 5500-EI PWR Install Manual

[SwitchA-Ethernet1/0/10]
remark-vlan 200
[SwitchA-Ethernet1/0/10] quit
Define the same VLAN mapping rules on Switch B. The detailed configuration procedure is
similar to that of Switch A and thus is omitted here.

Configuring Traffic Mirroring and Redirecting Traffic to a Port

Network Requirements
A company uses a switch to interconnect all the departments. As shown in
The marketing department is connected to Ethernet 1/0/1 of the switch. The IP address
segment for the hosts of the marketing department is 192.168.1.0/25, and the hosts
access the Internet through the switch.
The R&D department is connected to Ethernet 1/0/2 of the switch. The IP address
segment for the hosts of the R&D department is 192.168.2.0/25, and the hosts access
the Internet through the switch.
The data monitoring device is connected to Ethernet 1/0/3 of the switch.
Configure traffic redirecting and traffic mirroring to satisfy the following requirements:
From 8:00 to 18:00 in working days, mirror the HTTP traffic from the marketing
department to the Internet to the data monitoring device.
From 8:00 to 18:00 in working days, redirect the HTTP traffic from the R&D department
to the Internet to the data monitoring device.
On the data monitoring device, the network administrator can analyze the HTTP traffic from
each department to the Internet.
Network diagram
Figure 1-12 Network diagram for traffic redirecting and traffic mirroring configuration
Configuration procedure
1) Define a time range for working days
traffic-remark-vlanid
1-36
inbound link-group
Figure
4003
1-12,