Vlink-Peer - 3Com 8807 Command Reference Manual

458 C 25: OSPF C C
HAPTER ONFIGURATION OMMANDS
If the router is an ABR, it will send a default route to the connected Stub area.
Using the default-cost command, you can configure the default route cost value.
In addition, on an ABR, you can configure the no-summary argument in the stub
command to prevent type-3 LSAs from entering the Stub area connected to this
ABR.
Related command: default-cost.
Example
# Set the type of OSPF area 1 to the Stub area.
[3Com-ospf-1] area 1
[3Com-ospf-1-area-0.0.0.1] stub

vlink-peer

Syntax
vlink-peer router-id [ dead { seconds | minimal multi-hello packets } |
retransmit seconds | trans-delay seconds | hello seconds | simple password |
md5 keyid key ]*
undo vlink-peer router-id
View
OSPF area view
Parameter
route-id: Router ID of virtual link peer.
dead seconds: Specifies the interval of dead timer. It ranges from 1 to 8192
seconds. This value must equal the dead seconds of the router virtually linked to it
and must be at least four times of hello seconds. The default value is 40 seconds.
dead minimal multi-hello packets: Specifies the virtual link to run Fast Hello
function. The default dead is 1 second. The packets argument refers to the
number of Hello packets sent within 1 second, in the range of 3 to 10.
retransmit seconds: Specifies the interval for re-transmitting the LSA packets on
an interface. It ranges from 1 to 8192 seconds. The default value is 5 seconds.
trans-delay seconds: Specifies the interval for delaying transmitting LSA packets
on an interface. It ranges from 1 to 8192 seconds. By default, the value is 1
second.
hello seconds: Specifies the interval for sending Hello packets on an interface. It
ranges from 1 to 8,192 (in seconds). This value must equal the hello seconds
value of the router virtually linked to the interface. By default, the value is 10
seconds.
simple password: Specifies the simple text authentication password, not
exceeding 8 characters, of the interface. This value must equal the authentication
key of the virtually linked peer.
keyid: Specifies the MD5 authentication key ID. Its value ranges from 1 to 255. It
must be equal to the authentication key ID of the virtually linked peer.