Configuring An Msdp Peer Connection - 3Com Switch 4800G 24-Port Configuration Manual

680 C 48: MSDP C
HAPTER
Creating an MSDP Peer
Connection
Configuring a Static RPF
Peer
Configuring an MSDP
Peer Connection
Configuration
Prerequisites
ONFIGURATION
To do...
Enter system view
Enable IP multicast routing
Enable MSDP and enter MSDP
view
An MSDP peering relationship is identified by an address pair, namely the address
of the local MSDP peer and that of the remote MSDP peer. An MSDP peer
connection must be created on both devices that are a pair of MSDP peers.
Follow these steps to create an MSDP peer connection:
To do...
Enter system view
Enter MSDP view
Create an MSDP peer
connection
n
If an interface of the router is shared by an MSDP peer and a BGP peer at the same
time, we recommend that you configuration the same IP address for the MSDP
peer and BGP peer.
Configuring static RPF peers avoids RPF check of SA messages.
Follow these steps to configure a static RPF peer:
To do...
Enter system view
Enter MSDP view
Configure a static RPF peer
n
If only one MSDP peer is configured on a router, this MSDP will be registered as a
static RPF peer.
Before configuring MSDP peer connection, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are
■
interoperable at the network layer.
Configuring basic functions of MSDP
■
Use the command...
system-view
multicast routing-enable
msdp
Use the command...
system-view
msdp
peer peer-address
connect-interface
interface-type
interface-number
Use the command...
system-view
msdp
static-rpf-peer peer-address
[ rp-policy ip-prefix-name ]
Remarks
-
Required
Disabled by default
Required
Disabled by default
Remarks
-
-
Required
No MSDP peer connection
created by default
Remarks
-
-
Required
No static RPF peer configured
by default