Setting The Spanning Tree Path Cost; Enabling And Disabling Spanning Tree Fast Start - 3Com SuperStack II Manual

112 C 4: W
HAPTER ORKING
Setting the Spanning
Tree Path Cost
Enabling and
Disabling Spanning
Tree Fast Start
W C L
ITH THE OMMAND INE
2 Enter the number of a port on the Switch unit. If the port selected is
working in VLT mode the display will show the port as being a member of
all current VLANs with
The port information for the Switch is displayed as shown in the example
below.
Unit 2, Port 1 Detailed Information
State:
StpCost:
VLAN Membership
VLAN ID Local ID
-----------------------------------------------------------
1 1
Select menu option:
You can set the spanning tree path cost on a port of the current Switch
using the
stpCost
To set the spanning tree path cost:
1 At the Top-level menu, enter:
bridge port stpCost
The following prompt is displayed:
Select bridge port (1-12):
2 Enter the number of the port.
The following prompt is displayed:
Enter new value (1-65535) [10]:
3 Enter the new value for the spanning tree path cost on the port.
You can enable or disable spanning tree fast start on a port of the current
Switch unit using the
To enable or disable spanning tree fast start:
1 At the Top-level menu, enter:
bridge port stpFastStart
The following prompt is displayed:
Select bridge ports (1-12) [1]:
I
NTERFACE
shown as
Tagging
Disabled fwdTransitions:
19 BroadcastStormControl:
Vlan Name
Default VLAN
command on the Port menu.
command on the Port menu.
stpFastStart
.
vlt
Tagging
None
0
Enabled