ABB IRB 6640 Product Manual page 92

2 Installation and commissioning
2.6.8. Installation of cooling fan for motors, axes 1 and 2 (option)
Continued
Required equipment
Equipment
Cooling fan
Cabling, cooling fans, axes
1 or 2.
Plate for customer
connections
Additional cabling to and
inside the controller
Material set fan axes 1 and
2
Cable harness inside
controller
Locking liquid
Standard toolkit
Circuit diagram
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
90
Art. no. Note
3HAC15374-1
3HAC023599-001 Choose this cabling if equipping the
robot with cooling fans on axis 1 or 2 .
3HAC025778-001 An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page
-
3HAC023999-001 The set includes:
•
•
•
3HAC025488-001
- Loctite 243. Used for the three tightening
screws.
- The content is defined in the section
Standard toolkit on page
- See the chapter
3HAC025744-001
These procedures include references to
the tools required.
91.
fan axes 1 & 2 cable harness
plate, customer
attachment screws and nuts.
409.
Circuit diagram.
Continues on next page
3HAC026876-001 Revision: F