GBC StreamPunch Ultra Service Manual page 47

RTP 2.8 Checking Obstruction in Paper Path
Use this RTP to checking for an obstruction in the paper path.
When inspecting for obstruction to paper path, look for any ripped pieces
of paper or any other objects like loose fasteners along the paper path. A
few key areas to inspect are shown below:
Area 1 (Entrance)
1. Open the Front Door.
2. Open the Bypass Panel.
3. Inspect the gap between the Drive Roller and the sheet metal panel
for any objects.
GBC StreamPunch Ultra/Ultra MP
Area 2 (Entrance Idler Panel Assembly)
1. At the top of Area 2 (Entrance Idler Panel Assembly), check if there is
a 2 to 3mm gap for sheet flow.
2. If the Lower entrance panel (PL #) is bent, Replace it (ARP #); If the
Inner Entrance panel (PL #) is bent, Replace it (ARP #).
11-05-2018
2-30
RTPS