Arp 3.24 Alignment Sensor Bracket And Alignment Sensor Bottom Guide Replacement - GBC StreamPunch Ultra Service Manual

ARP 3.24 Alignment Sensor Bracket and Alignment Sensor Bottom
Guide Replacement
PARTS LIST ON PL 4.10
Removal Procedure
Use this procedure to remove and install the Alignment Sensor Bracket
and the Alignment Sensor Bottom Guide.
WARNING
Do not perform Repair activities with the power on or electrical
power supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury.
1. Disconnect the Power Cord.
2. Do ARP 1.6 to remove the Rear Cover.
3. Do ARP 3.1 to remove the Punch Module.
4. Unplug the Skew Sensor Connector and release the Cable from the
Cable Clamps.
5. Remove the Steering Idler Roller Cover.
6. Unplug the Alignment Sensor Connector
Adjustments/Repairs
7. . Remove M3 Nuts (2) that hold the Brackets.
8. Remove both upper and lower brackets as shown, do not pull on the
Align sensor wires.
9. The lower bracket can be replaced at this time.
GBC StreamPunch Ultra/Ultra MP
02-03-2017
4-120