GBC StreamPunch Ultra Service Manual page 39

2 PAPER JAMS
This section describes paper jams based on the position of the lead edge/
trail edge of the first jammed sheet.
RTP 2.1 Jam Type A
Do the following if the lead edge stopped by nip N1.
1. Check to see if there is any obstruction to paper flow at the entrance
of the machine
Do RTP 2.8 Checking Obstruction in Paper Path - Area 1 (Entrance)
This clears the fault
Yes- Return to normal operation; No- Go to Step 2
2. Do RTP 3.1 to check Sensors S21 and S25.
This clears the fault
Yes- Return to normal operation; No- Go to Step 3
3. Do RTP 5.1 Checking Stepper Motors to check Bypass Motor M8.
This clears the fault
Yes- Return to normal operation; No- Go to Step 4
4. Do GP 6.14 Idler Roller Inspection and Cleaning and GP 6.15 Drive
Roller Inspection and Cleaning, to inspect and clean the rollers in Nip
N1 (PL 2.6).
This clears the fault
Yes- Return to normal operation; No- Escalate to next level
GBC StreamPunch Ultra/Ultra MP
11-05-2018
2-22
RTPS