Hfsi; Final Action - GBC StreamPunch Ultra Service Manual

HFSI

Replace the part if over threshold (See Pages 1-5 and 1-6).
Note down the DIE CYCLE counts (GP 6.1.8) and PUNCH CYCLE count
(GP 6.1.9) when performing HFSI.

FINAL ACTION

This section explains the actions a technician should take at the end of
every service call. With each step, verify that the system runs smoothly
and paper jam free.
Purpose
Ensure acceptable punch quality, punch performance, and punch
appearance are satisfactory and to complete administrative tasks.
GBC StreamPunch Ultra/Ultra MP
PROCEDURE
1. Install/close all covers and doors.
2. Inspect each Die Set visually and lubricate as needed. See GP 6.7,
Die Set Service
3. Use the customer's primary Die Set pattern to run 200 simplex printed
test sheets through the punch mode and examine the output for clean
hole quality and even hole alignment.
4. Use the customer's primary Die Set pattern to run 200 duplex printed
test sheets through the punch mode and examine the output for clean
hole quality and even hole alignment.
5. Use any of the customer's secondary Die Set pattern to run 100
simplex printed test sheets through the punch mode and examine the
output for clean hole quality and even hole alignment.
6. Run 100 sheets simplex and 100 sheets duplex through the punch
bypass mode.
7. Clean out all paper chips (chad) and paper dust from the chip tray,
the bottom of the machine and from the floor around the bottom of the
machine. See GP 6.10 Base Cleaning.
8. Explain to the customer the service work that was performed and
ensure they are satisfied before you close the call.
Service Call Close
1. Record your service activities along with the Punch Cycle Count.
02-03-2017
1-7
Service Call Procedures