Gp 6.2.10 Align Offsets Adjustment - GBC StreamPunch Ultra Service Manual

GP 6.2.10 ALIGN OFFSETS Adjustment

Do the following to setup the align offsets.
Procedure
Do the following to make adjustments to the Align Offsets. The Align
Offsets is same as the Alignment Offset in the User setting, except:
- The User Alignment setting adjusts the Alignment position of all
sheets (regardless of size) that are processed by StreamPunch
Ultra/Ultra MP.
- The ALIGN OFFSETS described here are performed to individual
sensors. Therefore adjusting a sensor's Align Offsets will only
impact the sheet sizes using that particular sensor.
The below table shows the sensor for each sheet size:
Sensor Sheet sizes
S11 none
S12 A4-LEF, A4 tab, A3-SEF
S13 LTR-LEF, LTR tab, 11x17-SEF
S14 none
S15 1/2LTR-LEF, 1/2LTR tab, LTR-SEF, Legal SEF
A5-LEF, A5 tab, A4-SEF
1. At the top level screen,
READY
SINGLE PUNCH
Press and hold both the Up Arrow button and the Down Arrow button
for 5 seconds.
Then while still holding down the Up Arrow button and the Down
Arrow button, press the Enter button.
GBC StreamPunch Ultra/Ultra MP
The Service User Interface screen will appear.
PAPER SIZE
MAX BYPASS
2. Press the down arrow so the return symbol is next to the words
ALIGN OFFSETS.
SKEW OFFSETS
ALIGN OFFSETS
3. Press the ENTER button when the return symbol is next to the words
ALIGN OFFSETS to display the ALIGN OFFSETS screen.
S11
S12
11-05-2018
6-39
*
*
*
General Procedures and Information